0
  • 聊天消息
  • 系统消息
  • 评论与回复
登录后你可以
  • 下载海量资料
  • 学习在线课程
  • 观看威廉希尔官方网站 视频
  • 写文章/发帖/加入社区
会员中心
创作中心

完善资料让更多小伙伴认识你,还能领取20积分哦,立即完善>

3天内不再提示

接收机电池低电压报警电路--Receiver Battery

报警电路图|报警器电路图 来源:本站整理 作者:佚名 2010-01-13 17:02 次阅读

接收机电池低电压报警电路--Receiver Battery Low Voltage Alarm

Here is another equally cool low voltage alarm circuit for your glider receiver battery that I've shamelessly stolen from George Steiner's book "A to Z--Radio Control Electronic Journal" (see below). I've modified it to use with small battery packs in R/C gliders. This design has a trigger voltage at about 4.3 volts, and it draws 1mA or less when quiet and about 4mA when buzzing. This can be constructed from parts fromt Radio Shack, though you may need to order a few through them.

The voltage of a receiver system is punctuated by low-voltage spikes every time the servo motors spin up, since the servos draw more than the battery can deliver. With large receiver battery packs, this is not as much of an issue, and it may not be noticeable. However with 270mA and smaller battery packs, particularly with more than two servos, low voltage alarms can chirp constantly, every time a servo moves. The challenge is to design in a little slack or delay, just enough so that you are not annoyed by constant chirping, but not too much so that the chirps can give you a warning before the battery is completely exhausted. Here, this "hysteresis" is adjusted with the capacitor. For large packs (600mA and above), no capacitor is probably needed, although I've been using a 1uF capacitor on my open class ship with 6 servos and a 600mA battery. For 270 mA and two servos, I'd suggest trying a 1uF capacitor. For 150mA or less, a 2.2uF capacitor works well. If you want to know only when the battery has finally reached the trigger voltage, try a 5uF (or 4.7uF) capacitor. The actual type of capacitor is not critical, but tantalum capacitors are physically smaller. If you want to worry about the polarity of the capacitor, the negative side should be directed toward the negative pole of the battery, but at these relatively low voltages compared to the capacitor rating, the polarity probably does not matter.

This circuit is set up for a four cell receiver battery pack at a trigger voltage of about 4.3 volts (about 1.1volts/cell). You can adjust R1 (here a 3.3k resistor) to change the trigger voltage of the circuit. For example, for a 5 cell pack, to change the trigger voltage to 5.5 volts, change R1 to 2.2k. For a three cell pack, to change the trigger voltage to 3.3 volts, change R1 to 6.8 k (or use two 3.3k resistors in parallel by soldering a resistor in each hole and twisting together the top leads). Because of slight variability in tolerances of the componants, you should check this little device with a variable power source and a voltmeter to confirm its trigger point. Alternately, use your digital voltmeter or expanded scale voltmeter to calibrate its chirp pattern by measuring the voltage of the onboard battery pack intermittently as you fly.

Make sure the band on the Zener diode is toward the "+" side (toward R1). Solder a battery connector or servo connector to the board with positive and negative as shown, and plug the connector into an unused slot in your receiver.


Radio Shack parts: Here again, you can use smaller rated resistors if you can get them--1/8 watt or less is fine. Tantalum capacitors are physically smaller, but any composition will work.

273-074

$2.99

Miniature Piezo Buzzer, 12v, PC board mount

271-312

$7.99

1/4 watt 5% carbon film resistors, 500 pieces (Take the plunge!)

276-1604

$2.26

Package of 15 PNP small signal 2N3906-type transistors. Could use

instead 276-2016 $0.59 2N3904 PNP transistors

RSU 11673505

$0.79

3.3v Zener diode (not on shelf--need to order 1-800-THE-SHACK)

272-1434

$0.59

1uf tantalum capacitor (see above for choice of capacitor)

RSU 11295888

$1.19

2.2uF tantalum capacitor (not on shelf--need to order)

272-1024

$0.49

4.7uF radial-lead electrolytic capacitor


Digikey (1-800-344-4539) part numbers: Digikey does sell the peizo buzzers, but they are much more expensive than those at Radio Shack and are larger as well.

2N3906-ND

$0.25

PNP general purpose amp/switch transistor

1N5226BMSCT-ND

$0.21

3.3v Zener diode 500mA

3.3KEBK-ND

$0.28/5

1/8 watt resistors

4.7KEBK-ND

$0.28/5

1/8 watt resistors

10KEBK-ND

$0.28/5

1/8 watt resistors

P2105-ND

$0.28

1.0uF Tantalum capacitor 16volt

P2022-ND

$0.26

2.2uF Tantalum capacitor 10volt

P2024-ND

$0.32

4.7uF Tantalum capacitor 10 volt

FP012C-5-ND

$3.96

3M clear 0.5" heat shrink tubing, 5 feet

声明:本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人,不代表电子发烧友网立场。文章及其配图仅供工程师学习之用,如有内容侵权或者其他违规问题,请联系本站处理。 举报投诉
  • 报警电
    +关注

    关注

    0

    文章

    2

    浏览量

    5906
收藏 人收藏

    评论

    相关推荐

    光束式半导体发信机和接收机电路

    光束式半导体发信机和接收机电路
    发表于 05-01 01:04 551次阅读
    光束式半导体发信机和<b class='flag-5'>接收机电路</b>

    调频接收机电路

    调频接收机电路:如图所示电路基础上接入TBA820M单功率放大器后构成的接收机电路,当电源电压为9V时输出功率可达1。6W。
    发表于 10-16 12:15 2701次阅读
    调频<b class='flag-5'>接收机电路</b>

    调幅接收机电路

    调幅接收机电路:
    发表于 10-16 12:18 1575次阅读
    调幅<b class='flag-5'>接收机电路</b>

    电感拾音接收机电路

    电感拾音接收机电路
    发表于 01-18 15:54 1665次阅读
    电感拾音<b class='flag-5'>接收机电路</b>

    单管FM接收机电路

    单管FM接收机电路
    发表于 03-14 14:53 2416次阅读
    单管FM<b class='flag-5'>接收机电路</b>

    集成电路载波接收机电路

    集成电路载波接收机电路
    发表于 03-19 10:54 653次阅读
    集成<b class='flag-5'>电路</b>载波<b class='flag-5'>接收机电路</b>图

    载波接收机电路

    载波接收机电路
    发表于 03-19 10:57 837次阅读
    载波<b class='flag-5'>接收机电路</b>图

    集成电路载波接收机电路

    集成电路载波接收机电路
    发表于 03-25 08:35 705次阅读
    集成<b class='flag-5'>电路</b>载波<b class='flag-5'>接收机电路</b>图

    载波接收机电路

    载波接收机电路
    发表于 03-25 08:38 1137次阅读
    载波<b class='flag-5'>接收机电路</b>图

    战波系统接收机电路

    战波系统接收机电路
    发表于 03-25 08:39 403次阅读
    战波系统<b class='flag-5'>接收机电路</b>图

    模拟接收机电路

    模拟接收机电路
    发表于 04-08 09:02 989次阅读
    模拟<b class='flag-5'>接收机电路</b>图

    迷童报警接收机电路

    迷童报警接收机电路图                
    的头像 发表于 07-28 15:44 2064次阅读
    迷童<b class='flag-5'>报警</b>器<b class='flag-5'>接收机电路</b>图

    精密接收机电池低电压报警 (Precision Receiv

    精密接收机电池低电压报警 (Precision Receiver Battery Low Voltage Alarm) Flyin
    的头像 发表于 01-09 08:45 3952次阅读

    电池组接收器的放电电路--Discharger for Re

    电池组接收机的放电电路--Discharger for Receiver Battery Packs
    发表于 01-13 17:00 1169次阅读
    <b class='flag-5'>电池组接收</b>器的放电<b class='flag-5'>电路</b>--Discharger for Re

    S9018单管超再生FM接收电路,FM receiver

    S9018单管超再生FM接收电路,FM receiver 关键字:S9018单管超再生FM接收电路
    的头像 发表于 09-20 19:14 4468次阅读