在linux使用HUMMINGGBIRD Debugger Kit V2连接目标板上e203提示出错是怎么回事？

在linux使用HUMMINGGBIRD Debugger Kit V2 连接目标板上e203提示出错如下:
(hbirdenv) root@linuxczp:/home/nuclei-hbird/hbird-sdk/application/baremetal/helloworld# make upload SOC=hbirdv2 BOARD=ddr200t CORE=e203 DOWNLOAD=ilm
Download and run helloworld.elf
riscv64-unknown-elf-gdb helloworld.elf -ex “set remotetimeout 240”
-ex “target remote | openocd -c ”gdb_port pipe; log_output openocd.log” -f ../../../SoC/hbirdv2/Board/ddr200t/openocd_hbirdv2.cfg”
—batch -ex “monitor reset halt” -ex “load” -ex “monitor resume” -ex “quit”
Open On-Chip Debugger 0.11.0+dev-02400-g1dac85c02 (2024-06-26-07:32)
Licensed under GNU GPL v2
For bug reports, read
    http://openocd.org/doc/doxygen/bugs.html
Remote communication error.  Target disconnected.: Connection reset by peer.
“monitor” command not supported by this target.
You can’t do that when your target is `exec’
“monitor” command not supported by this target
找不到目标板上的器件,底层跟踪如下各管脚时序如下:

请问一下大神们，正确的时序应是怎么样的？忘指导一下，不甚感激！